Quantcast
Channel: Let's Make Robots! | RobotShop - Comments for "My Arduino + CMUcam indoor rover."
Browsing latest articles
Browse All 20 View Live

Hi GroG, Cheers for your

Hi GroG,Cheers for your comment, I will try to reply to as many of your points as possible, in order.Yes, the camera is RS232, and I have hooked the Arduino's 1+2 pins up to the CMUcam's TTL RS232 pins...

View Article


I am trying to use the

I am trying to use the CMUcam1 with my Picaxe 28x1 board, am I to connect the TTL recieve pin from the camera board to the digital input on my Picaxe? And the transmit pin from the camboard to the...

View Article


Arduino and CMUcam interface

Hi Robert, Could I get some information on Arduino and CMUcam interfacing? Which Arduino did you use for this project? Do you see any limitations if Arduino Uno is used.CheersShital  

View Article

Hi

Hi Shital,The CMUcam was interfaced to the Arduino via TTL-level RS232. This involved 3 wires for RX, TX and GND.The Arduino I used was a StickDuino (http://spiffie.org/kits/stickduino/) - but you...

View Article

Hi RobertThanks for your

Hi RobertThanks for your post. Could you be able to share the schematics for the interface? Regards

View Article


Arduino1+2 pins

What are these Arduino 1+2 pins that is being referred to in the above comment? Can we use RS232 shield ?

View Article

serial pins

From memory I was using Software Serial through pins 1 and 2 (TX and RX) - so, yes, you should be able to use an RS232 shield and whatever pins you like.

View Article

unfortunately no :(

Unfortunately I have since disassembled the arduino + camera interface, but there should be plenty of examples - a simple google brought up this one on LMR...

View Article


Hi, i am from singapore. may

Hi, i am from singapore. may i know how do u get the CMUCAM to communicate to the Arduino?? Say i want to print the output in the serial monitor. The output of the CMUCAM i suppose is in this format...

View Article


CMUcam+Arduino interface

Hi Robert, Need some advice. Appreciate your inputs. I have a small project going where I need to capture an image, perform some postprocessing to retrieve some data from the image and then upload it...

View Article
Browsing latest articles
Browse All 20 View Live